Filter
Top Products
4 - 5
4. OPERATION
4.2 Program operation mode
4.2.1 What is program operation mode?
Make selection with the input signals or by communication from among the programs that have been
created in advance using the Servo Configuration software, and perform operation with Forward
rotation start (ST1).
This servo is factory-set to the absolute position command system.
As the position data, the absolute move command ("MOV" command) used to specify the target
address or the incremental move command ("MOVI" command) used to specify the moving distance
can be set. Note that the movable range is -999999 to 999999 [
10
STM
m]. Positioning is enabled
within this range.
Setting range:
999999 to 999999 [ 10
STM
m] (STM feed length multiplication parameter No.1)
Position data setting range
[ 10 m]
999999
999999
STM