Filter
Top Products
6 - 20
6. SERVO CONFIGURATION SOFTWARE
6.7.4 Output signal (DO) forced output
Each servo amplifier output signal is forcibly switched on/off independently of the output condition of the
output signal.
Click “Test” on the menu bar and click “Forced Output” on the menu.
When the above choices are made, the following window appears:
Since this window shows the precautions for use of the MR-J2S-B, click the "OK" button.
Clicking it displays the next window.
a)
b)
c)
(1) Signal ON/OFF setting ( a), b) )
Choose the signal name or pin number and click the “ON” or “OFF” button to write the corresponding
signal status to the servo amplifier.
(2) DO forced output window closing ( c) )
Click the “Close” button to cancel the DO forced output mode and close the window.