Filter
Top Products
1 - 3
1. FUNCTIONS AND CONFIGURATION
1.1.2 System configuration
This section describes operations using this servo.
You can arrange any configurations from a single-axis to max. 32-axis systems. Further, the connector
pins in the interface section allow you to assign the optimum signals to respective systems. (Refer to
Sections 1.1.3 and 3.3.3.) The Servo configuration Software (refer to Chapter 6) and personal computer
are required to change or assign devices.
(1) Operation using external input signals
(a) Description
The following configuration example assumes that external input signals are used to control all
signals (devices).
The I/O signals are as factory-set.
(b) Configuration
The following configuration uses external I/O signals. The personal computer is used with Servo
configuration Software to set creation of a program, change and monitor the parameters.
Servo amplifier
External I/O
signals
Power supply
Servo motor
RS–232C
Servo configuration
Software
Personal
computer
CN1A CN1B
CN2 CN3