Filter
Top Products
Configuration and Use Manual 55
Required Configuration Optional ConfigurationUsing the TransmitterUsing a DeviceNet Tool
Chapter 8
Optional Configuration
8.1 Overview
This chapter describes transmitter configuration parameters that may or may not be used, depending
on your application requirements. For required transmitter configuration, see Chapter 6.
Table 8-1 lists the parameters that are discussed in this chapter. Default values and ranges for the most
commonly used parameters are provided in Appendix A.
Note: All ProLink II procedures provided in this chapter assume that you have established
communication between ProLink II and the Model 2400S DN transmitter and that you are complying
with all applicable safety requirements. See Chapter 4 for more information.
Note: If you are using Pocket ProLink, the interface is similar to the ProLink II interface described in
this chapter.
Note: All DeviceNet tool procedures provided in this chapter assume that you have established
communication between the DeviceNet tool and the Model 2400S DN transmitter and that you are
complying with all applicable safety requirements. See Chapter 5 for more information.
Table 8-1 Configuration map
Tool
Topic Subtopic ProLink II DeviceNet tool Display Section
Volume flow
measurement for gas
✓✓ 8.2
Cutoffs ✓✓ 8.3
Damping ✓✓ 8.4
Flow direction ✓✓ 8.5
Events ✓✓ 8.6
Slug flow ✓✓ 8.7
Status alarm severity ✓✓ 8.8