Filter
Top Products
Configuration and Use Manual 15
Using the Transmitter User Interface
Startup Using ProLink IITransmitter User InterfaceBefore You Begin
To change from decimal to exponential notation (see Figure 3-5):
1.
Select until the rightmost digit is flashing.
2.
Scroll to E, then Select. The display changes to provide two spaces for entering the exponent.
3. To enter the exponent:
a.
Select until the desired digit is flashing.
b.
Scroll to the desired value. You can enter a minus sign (first position only), values
between 0 and 3 (for the first position in the exponent), or values between 0 and 9 (for the
second position in the exponent).
c.
Select.
Note: When switching between decimal and exponential notation, any unsaved edits are lost. The
system reverts to the previously saved value.
Note: While in exponential notation, the positions of the decimal point and exponent are fixed.
Figure 3-5 Numeric values in exponential notation
To change from exponential to decimal notation:
1.
Select until the E is flashing.
2.
Scroll to d.
3.
Select. The display changes to remove the exponent.
To exit the menu:
• If the value has been changed,
Select and Scroll simultaneously until the confirmation screen
is displayed.
-
Select to apply the change and exit.
-
Scroll to exit without applying the change.
• If the value has not been changed,
Select and Scroll simultaneously until the previous screen
is displayed.
SX.XXXEYY
Sign
Digits
Enter a four-digit
number; three digits
must fall to the right
of the decimal point.
E
Exponent
indicator
Sign or Digit (0–3)
Digit (0–9)