Filter
Top Products
Configuration and Use Manual 29
Required Transmitter Configuration
Required Configuration Optional ConfigurationUsing the TransmitterUsing a DeviceNet Tool
Figure 6-3 Configuring measurement units
Density
Temperature
Flow
Pressure
ProLink >
Configuration
Mass flow unit
Volume flow unit
(liquid)
Class: Analog Input Point Object (0x0A)
Instance: 1
Attribute ID: 102
Value: See Table 6-2
Service: Set
Density unit
Class: Analog Input Point Object (0x0A)
Instance: 3
Attribute ID: 102
Value: See Table 6-5
Service: Set
Class: Analog Input Point Object (0x0A)
Instance: 2
Attribute ID: 102
Value: See Table 6-3
Service: Set
Temperature unit
Class: Analog Input Point Object (0x0A)
Instance: 4
Attribute ID: 102
Value: See Table 6-6
Service: Set
Pressure unit
Class: Calibration Object (0x65)
Instance: 1
Attribute ID: 29
Value: See Table 6-7
Service: Set
DeviceNet tool
DisplayProLink II
Units
Off-line maint >
Off-line config
Vol (or GSV)
Density
Mass
Temperature
Pressure
Note: To configure a volume flow
measurement unit for gas, see Section 8.2.