Filter
Top Products
4-14
Creating a Loop
Studio Color LCD Controller
Creating a Loop
A loop is a sequence of pages that repeats continuously until
you stop it. You can vary the rate of playback using the
<Rate>
knob.
You must perform the two basic steps shown below:
Step 1. Record the pages as a contiguous block in the same
memory. For example, memory 1, pages 1—10.
Step 2. Designate un-initialized pages that “bracket” (one
before and one after) the pages in the loop.
Step 1: Record the Pa
g
es
Recording pages was covered previously in the section titled
“Creating a Program” on page 4-10. When you are recording
a loop, all pages must be contiguous in the same memory (for
example, memory 1, pages 1—10).
Step 2: Record Un-Initialized Pa
g
es
An un-initialized page acts as a “placeholder” to indicate the
beginning and end of your loop. Normally, you must create
two un-initialized pages (one before the first page of your
loop, one after the last page of your loop). See Figure 4-3.
Figure 4-3. The pages you wish to play as a loop
are bracketed on either side by un-initialized pages.
Page 10
Page 11
Page 12
Page 13
Page 14
Page 15
Page 9
Page 16
Un-Initialized Page
Un-Initialized Page
Pages
Loop
From 10
to 15