Filter
Top Products
Studio Color LCD Controller
Submasters
6-25
6
Assigning a Channel for Master Dim
This section explains how to use a submaster as the “master
dim controller”. Once you assign a channel for master dim,
the same channel cannot be used to control fixtures. For
example, if you select channel 1 for master dim, you cannot
use channel 1 to control fixtures.
Note When the master dim is assigned to a channel, you
should not use the Studio Color LCD controller for
master dim control; master dim should be controlled
by the submaster “master dim controller”.
1. Select
; from the Main menu, as shown below:
2. Press the Cursor
<Down>
arrow key. The LCD display then
appears similar to the one shown below:
3. Use the Construct
<Up>
and
<Down>
arrow keys to select a
channel for master dim. Remember that the channel you
assign to master dim cannot also be assigned as a submaster.
4. After you set the channel for master dim, you can assign
submaster channels as shown in the next section.
Assigning Fixtures to a Submaster
To have a particular submaster control the dimming or color
of a particular fixture(s), you have to assign that fixture(s) to
that submaster. There are 12 submasters available (or eleven
if you assigned one channel to master dim).
);? ;:;(
-D((
1 ;:4+$2.%JK@8+5+++$/
! ) *