Filter
Top Products
4-18
Setting Rate and Delay Time
Studio Color LCD Controller
Setting Rate and Delay Time
Before continuing, make sure the controller is ready for
programming as shown in Figure 4-1 on page 4-3.
You can control the speed of your loop using the
<Rate>
knob
and the Delay construct. The Delay construct (also called
delay time) determines how long each page in the loop
“plays” before moving on to the next page, and the
<Rate>
knob lengthens or shortens the delay time.
Note The Rate and Delay settings are ignored if you are
using audio advance as described in the section titled
“Audio Input Playback” on page 6-27.
Using the
<Rate>
knob to control playback is referred to
throughout this manual as auto advance.
Playing Back the Loop
1. Use the Page
<Up>
and
<Down>
arrow keys to select a page in
the loop that you wish to begin with. (If you want the loop to
initially run from the first page on, select the first page; if you
want the loop to run from the third page on, select the third
page, and so on.)
2. Press the
<Auto>
key located over the
<Rate>
knob. The Auto
LED comes ON and the loop runs beginning from the page
you selected.
Varying the Playback Rate
While the loop is running, turn the
<Rate>
knob clockwise to run the loop faster or
counterclockwise to run the loop slower.
rate
shorter than
Delay setting
longer than
Delay setting