Filter
Top Products
7-26
Macintosh
Studio Color LCD Controller
described in the section titled “Connecting the Computer and
Controller” on page 7-24.
1. Start White Knight. Press Command+U to open the Serial
Port Settings dialog box and set the serial port for all of the
following:
• Serial port type: Modem (click the telephone icon)
• Baud rate: 9600
•Parity: Ignore
• Databits: 8
• Stopbits: 1
• Duplex: Full
2. Click OK to accept the serial port settings.
3. Press Command+O+E to open the Emulation Options dialog
box and set the following:
• Terminal Emulation: VT100
• Pre-Emulation filter and Post-Emulation filter: make
sure both filters are off as indicated by the absence of an
“X” mark in the adjacent boxes.
4. Click OK to accept the emulation options.
Backing Up (Downloading) Memory from
Controller to Computer
The procedure that follows is based on White Knight v11.14.
Consult the documentation provided with your copy of White
Knight if you are using a different version.
Make sure you followed the procedure in both the following
sections before continuing:
• “Connecting the Computer and Controller” on page 7-24
• “Setting Up the Software” on page 7-25