Filter
Top Products
4-6
Programming Guided Tour
Studio Color LCD Controller
10. Use the joystick to position the beam in a different place of
your choosing.
11. Press the
<Record>
key to save page 2.
Recording Page 3
1. Press the
<Select>
key; it flashes.
2. Press the Page
<Up>
arrow key to select page 3.
3. Press
<Record>
to complete the page copy.
4. The controller is now set for memory 1, page 3. Press the
<Select>
key; it flashes.
5. Press the
<Address>
keys of the fixtures you want to program.
6. Press the
<Gate>
key, then use the Construct
<Up>
and
<Down>
arrow keys to select /.
7. Press the
<Color>
key and select a different color of your
choice.
8. Use the joystick to position the beam in a different place of
your choosing.
9. Press the
<Record>
key to save page 3.
Recording Page 4
Use the same procedure as for recording page 3, making sure
you do all of the following:
1. Select a value of
%5 for the Delay construct.
2. Position the beam in a different place than in page 3.
3. Press
<Record>
when you’re finished.