Filter
Top Products
Studio Color LCD Controller
Setting CSpeed
3-21
3
CSpeed
This option is accessible only through the menus. For more
information on accessing menus, see the section titled
“Setting CSpeed” on page 3-21.
(Color change speed.) This option determines how fixed
color wheel changes occur: at the fastest possible speed (at
the beginning of beam movement), or at the speed set by the
MSpeed construct (the color change completes at the same
time as the beam reaches its destination).
You can select either
)* (default; change
occurs as quickly as possible) or
)* (change
occurs smoothly over the MSpeed time value).
Setting CSpeed
You must set the parameters for the CSpeed construct using
the controller’s menu system, not using the Construct keys.
1. Toggle the
<Menu>
key until the LCD display appears similar
to the one shown below:
2. Press the
<Select>
key, then press the numbered Address keys
corresponding to all fixtures you wish to program. The LCD
display then appears similar to the one shown below:
3. Select
using the Cursor
<Left>
and
<Right>
arrow keys
located on either side of the
<Menu>
key.
7#88 #+ -*#+
9 :),
9 :#0/;-#'
cursor