Filter
Top Products
7-28
Macintosh
Studio Color LCD Controller
Verifying the Transfer
Open the Get Info window on the file you just captured to
make sure the file is about 256KB in size. If the file was
256KB, you are finished.
• If the file was larger than 0KB but less than 256KB, the
most likely cause was that something interrupted the
transfer. Check the cable connections on both ends,
verify the cable or replace it with a known working cable.
Begin again with the section titled “Setting Up the
Software” on page 7-25, making sure you do not press
the
<Select>
key on the controller or close the file capture
until the transfer is complete.
• If the file was 0KB, the most likely reason is a faulty
cable or connection. Check the cable connections on
both ends, verify the cable or replace it with a known
working cable. Begin again with the section titled
“Setting Up the Software” on page 7-25.
Restoring (Uploading) Memory from
Computer to Controller
Make sure you followed the procedure in both the following
sections before continuing:
• “Connecting the Computer and Controller” on page 7-24
• “Setting Up the Software” on page 7-25
1. Press and hold down the
<Erase>
key on the controller’s front
panel (about 10 seconds) until its LCD display shows the
following:
)(;$2$
;()!D<;0:D