Filter
Top Products
4-12
Creating a Program
Studio Color LCD Controller
Step 6: Press the Record Key
When you are finished editing constructs, press the
<Record>
key to save your page.
Note After recording the page, the address LEDs of all
fixture numbers with the Gate construct set to
/
come ON. If the Gate construct is set to
), the
address LED will not be on, regardless of the other
construct parameter values.
Where To Go From Here
After programming your first page, you can do the following:
• Program additional pages the same way. Be sure to
select an unprogrammed page first.
• Create a loop: A loop is a sequence of pages that runs
continuously until you stop it. Pages you wish to run as a
loop must be a contiguous block in the same memory (for
example, memory 1, pages 1—10). For more
information, see the section titled “Creating a Loop” on
page 4-14.
• Page copy: Copy entire pages from one location in
memory to another. This can save you time if you want
to create pages with slight variations, such as movement
or color changes. For more information, see the section
titled “Page Copy” on page 4-13.
• Block copy and reverse block copy: Similar to page
copy, block copy allows you to copy ranges of pages
from one location to another. Reverse block copy copies
the pages in the reverse order. For more information, see
the section titled “Block Copy (and Reverse)” on page
4-16.
• Preset programming: By assigning a page or a loop to
one of the numbered Preset keys, you can recall (play
back) the page or loop at any time at the push of a button,
or remotely using an analog controller as described in
Chapter 6. For more information, see the section titled
“Preset Programming” on page 4-19.