Filter
Top Products
3-18
Using the Construct Keys
Studio Color LCD Controller
4. Press the
<Gate>
key and use the Construct
<Up>
and
<Down>
arrow keys to select /.
5. Use the joystick to direct the beam at a reference point (wall,
screen, or other surface).
6. Press the
<Mode>
key, then use the Construct
<Up>
and
<Down>
arrow keys to select ))'* as shown
below:
7. Press the
<Green>
key and use the Construct
<Up>
and
<Down>
arrow keys to select a value of 5.
8. Press the
<Blue>
key and use the Construct
<Up>
and
<Down>
arrow keys to select a value of 5
9. The result is a 100% red beam. Press the
<Red>
key and use
the Construct
<Up>
and
<Down>
arrow keys to vary the value
of the construct from 0 to 255. You should see a red beam of
varying intensities.
10. Press the
<Mode>
key and use the Construct
<Up>
and
<Down>
arrow keys to select ))'*.
11. Press the
<Red>
key and use the Construct
<Up>
and
<Down>
arrow keys to vary the value of the construct.
• From 0 to about 122 (48%), the beam rapidly increases in
intensity.
• The beam reaches a minimum intensity at about 140
(55%).
• From about 141 (55%) to 255 (FF%), the beam rapidly
increases in intensity again.
12. With the Red construct at full intensity, try varying the Green
and Blue constructs to see the effect on color mixing.
*)/,
/#))'*-#'