Filter
Top Products
7-32
Crossloading
Studio Color LCD Controller
Consult Appendix C for a complete selection of cabling and
connector wiring diagrams.
Crossload Procedure
The source controller is the one you want to transfer data
from; the destination controller is the one you want to
transfer data to.
1. Toggle the
<Standby>
keys on each controller until their
Standby LEDs come ON.
2. Press and hold the
<Record>
key on the source controller
(about 10 seconds) until its LCD display shows the
following:
3. Press and hold the
<Erase>
key on the destination controller
(about 10 seconds) until its LCD display shows the
following:
4. Press the
<Record>
key on the source controller to start the
transfer. While the transfer is taking place, the LCD display
on the destination controller appears similar to the one shown
below:
Note Press the
<Select>
key on each controller (in any
order) at any time to stop the transfer. No data
corruption will result; stopping the transfer only limits
D);$2$-
;77()</
)(;$2$
;()!D<;0:D
D);$2$
*#'-#''