Filter
Top Products
3-14
Using the Construct Keys
Studio Color LCD Controller
Xfade Key
(Crossfade.) Crossfade affects only the following Studio
Color fixture features: Dim, Lens 1, Lens 2 and color
mixing.
Xfade is the length of time required for a value change in one
of the four Xfade constructs to complete. You can select a
value for Xfade from 0.1 second to 99 seconds.
For example, suppose the Dim construct is set to 99 (full
bright) on page 1, and 0 (full dark) on page 2. Setting a value
of 3.0 seconds for Xfade on page 2 means the fixture will
fully dim out in 3.0 seconds when you advance from page 1
to page 2.
Xfade, like the Delay construct, is a page-wide construct; that
is, it affects all fixture numbers (fixtures) on any particular
page.
Note Loop (sequence) only: If you want a particular
transition to be completed before the next page of a
loop (sequence) begins, your selection for Xfade must
be less than or equal to your selection for Delay. If
Xfade is longer than Delay, the transition will not be
completed before the next page begins. See “Delay
Key” on page 3-20.
69 14.58 36 63.78 3 147.90
68 15.56 35 65.82 2 151.00
67 16.57 34 67.89 1 154.13
0157.28
Table 3-2. MSpeed Movement Times
MSpeed
Value
Time
(sec.)
MSpeed
Value
Time
(sec.)
MSpeed
value
Time
(sec.)