Filter
Top Products
Studio Color LCD Controller
Programming Guided Tour
4-7
4
Manually Playing Back Pages 1 Through 4
1. Use the Page
<Up>
and
<Down>
arrow keys to select page 1, as
shown below:
2. The fixture(s) programmed for page 1 should now display the
color and position you selected for them.
3. Press the Page
<Up>
arrow key to select page 2. The
fixture(s) programmed for page 2 should now display the
color and position you selected for them. Do the same for
pages 3 and 4.
Review
You have now created and manually played back a simple
four-page program. The next sections show you how to
create a loop out of those four pages and then how to record
that loop or any of the pages in the loop as a preset.
Creating a Loop
A loop is a sequence of consecutive pages that continually
plays back until you stop it.
Normally, you create a loop by bracketing the pages on either
side of the loop by un-initialized pages; however, since the
first page in this sample loop is page 1, only one un-
initialized page is required.
1. Use the Page
<Up>
and
<Down>
arrow keys to select memory
1, page 5.
2. Press the
<Select>
key; it flashes.
7#88 #+ -*#+