Filter
Top Products
6-30
Remote Enable
Studio Color LCD Controller
3. To return from “live” control press the
<Select>
key. The
Select LED stops flashing and the selected fixtures return to
their original programmed settings.
Remote Enable
Located on the rear panel of the controller is a Remote
Enable connector that allows you to remotely enable and
disable the controller as described below:
• Sending a voltage of 0 V DC disables the controller (all
fixtures go dark, all wheels stop moving, and all in-
progress moves finish immediately).
• Sending a voltage between +5 V to +16 V DC to returns
the controller to its previous state. If the controller was
previously in Standby (with the Standby LED ON), the
controller returns to Standby; if the controller was not
previously in Standby, the controller resumes operation.
The female 3.5 mm (1/8 in) mini-phone jack accepts a 3.5
mm mini-phone connector (male). (The controller functions
normally with nothing attached to the Remote Enable
connector.)
Figure 6-6. Polarity of the remote enable connector.
Tip +Sleeve -