Service Contact Information
After installing and logging on to the 6416SW, you should enter the location of the
6416SW and the name of the appropriate person to contact in case of a failure in the
ATM subsystem or with the 6416SW
To do so, enter the following commands:
SET DEVICE LOCATION to specify where the 6416SW is installed
SET DEVICE CONTACT to specify the name of the service personnel to contact.
Console Prompt
3Com also recommends that you customize the prompt used by each 6416SW console.
This helps you to easily recognize the 6416SW to which you are connected when you
are logged on to a remote switch.
The default prompt is:
ONcoreATM>
Suggestion: To make it easier to recognize the 6416SW by its command prompt, set
the prompt to the name of the 6416SW used in the SET DEVICE NAME command.
See the
ONcore Switching Hub/CELLplex 4000 ATM Command Reference Guide
for
more information.
To customize the 6416SW management prompt, use the SET TERMINAL PROMPT
command.
ONcoreATM>set terminal prompt ATM2 [ENTER]
ATM2>
5-11
