SNMP Support
In a campus environment managed by the Simple Network Management Protocol
(SNMP), the 6416SW module acts as an SNMP agent allowing you to configure all ATM
modules in the hub using SNMP.
6416SW software contains a community table with up to ten IP addresses. Each IP
address has one of the following access attributes assigned:
Read-only
Read-write
Read-trap
Trap
All (read-write and trap).
The 6416SW module sends alerts to the IP addresses in the community table that have
either trap, read-trap, or all assigned. The 6416SW and ATM media modules can be
configured via SNMP from stations whose IP addresses have either read-write or all
assigned. The 6416SW module can be monitored from stations whose IP addresses
have read-write, read-trap, read-only,orall assigned.
After the IP address of an SNMP station is entered in the 6416SW community table, the
6416SW module can send SNMP alarms and alerts to the SNMP station.
6-2 ONcore ATM Switch/Control Module: Installation and User's Guide
