A SERVICE OF

logo

To save the changes made to an individual parameter, enter the parameter name in the
SAVE command. For example, if you changed the type of interface used on an ATM
port, you would save this setting as follows:
ONcoreATM> set port 1.3 enable UNI [ENTER]
Port set
ONcoreATM> save module_port [ENTER]
ONcoreATM>
Note that if you changed configuration settings for the DEVICE or TERMINAL, these
values are not saved using the SAVE MODULE_PORT command. To save these
settings, you must use the SAVE DEVICE and SAVE TERMINAL commands.
5-26 ONcore ATM Switch/Control Module: Installation and User's Guide