A SERVICE OF

logo

Logon Procedure
You specify the 6416SW by entering its IP address with the TELNET command:
C:\ telnet 123.94.2 2.9 [ENTER]
Once you are connected to the remote switch, you must log on by entering the correct
password. Afterwards all the commands you enter are run on the remote module as if
entered from a local 6416SW session.
To log off from a TELNET session, enter the LOGOUT command. The LOGOUT
command disconnects the TELNET connection and reconnects you to the local 6416SW
accessed through your configuration console. The following message is displayed with
the local management prompt:
ATM2 logout [ENTER]
Bye
Remote session completed
C:\
4-13