Isolating and Reconnecting ATM Media Modules
Use the SET MODULE command to:
Isolate and reconnect ATM media modules to the ATM network.
Enable and disable ATM media modules that are connected to the network.
When you isolate an ATM media module from the network, it remains in Reset mode
and no activity takes place on it. Its current configuration settings cannot be accessed
by the network. In order to use the module for ATM data transmission, you must
reconnect it to the network and enable it.
Fault Management
The 6416SW fault management function allows the administrator to report information
on ATM media modules and ports.
For example, to display the status of all ATM ports in the 6416SW, you enter:
ONcoreATM> show port all [ENTER]
Port display for module ONcore ATM 1 Mbps UNI Module
Port Type Mode Status
--------------------------------------
4. 1 UNI disabled UP-OKAY
4. 2 NNI enabled UP-OKAY
4. 3 UNI disabled UP-NO ACTIVITY
4. 4 UNI disabled UP-OKAY
----- more -----
Port display for module ONcore ATM 1 Mbps UNI Module
Port Type Mode Status
--------------------------------------
12. 1 NNI enabled UP-OKAY
12. 2 UNI enabled UP-NOT IN SERVICE
12. 3 SSI disabled UP-NO ACTIVITY
12. 4 SSI disabled UP-OKAY
ONcoreATM>
5-33
