A SERVICE OF

logo

Open as PDF
next previous
ATM Connection Problems
No Connection between Two ATM Hub in the Same Cluster
Steps to Take:
1. Use the SHOW PORT command to:
Make sure that the ATM media port at each end of the connection is configured
with an SSI interface. If not, use the SET PORT command and specify SSI as
the interface parameter.
Make sure that the the status of each port is OKAY. If not, follow the procedure
described in “Diagnosing Problems with ATM Ports Attached to ATM Devices”
on page 7-20.
2. Make sure that the bandwidth specified is the same at both ends of the trunk.
3. Contact your 3Com service representative.
7-47