A SERVICE OF

logo

Connecting ATM media Modules
After setting the ATM address, you must connect the ATM media modules to the
network. This is necessary because the factory default setting isolates them from
receiving network traffic.
To connect an ATM media module, you use the SET MODULE command:
ONcoreATM> set module 3 connected [ENTER]
Afterwards, you can enable individual ports on the module and configure an ATM
interface for each port. This requires the SET PORT command and is described in the
next section, “Enabling ATM Ports and Interfaces” on page 5-15.
5-14 ONcore ATM Switch/Control Module: Installation and User's Guide