A SERVICE OF

logo

Figure 4-1 shows an example of an 6416SW remote login. Note that once you are
connected to 6416SW A, you can remotely log on and manage the 6416SW modules in
either hub B or hub C.
Note: The TELNET protocol is not routable.
Modem
Modem
Hub B
Hub C
Hub A
RS-232
Console Port
of a
6416SW Module
Figure 4-1. Working in Remote 6416SW Sessions
You can set a timeout period for a remote 6416SW by entering the SET TERMINAL
TIMEOUT command. When this value is exceeded, the system automatically logs you
off the remote 6416SW session and returns you to your local session.
Although any unsaved configuration changes are still active, they will be lost the next
time you reset or reboot the remote 6416SW. To save these changes, you must
re-establish the remote session and enter the SAVE command.
4-14 ONcore ATM Switch/Control Module: Installation and User's Guide