A SERVICE OF

logo

Modifying Configuration Settings
Using the SET command, you can change the configuration settings for any of the
following parameters:
Alert
ATM_ESI
Clock
Community
Device
LAN_emul
Logical_link
Module
Static_route
Port
PVC
Terminal
TFTP
Trace.
Important: Remember that (except for SET CLOCK, ATM_ESI, PVC, TRACE, and
LAN_EMUL CONFIGURATION_SERVER) the changes you make with the SET
command are not saved permanently in nonvolatile memory. To do so, you must use
the SAVE command before logging off. See “Saving Configuration Settings and
Logging Off” on page 5-25 for more information.
5-32 ONcore ATM Switch/Control Module: Installation and User's Guide