Upgrading FPGA Picocode in ATM Modules
To upgrade hardware picocode in the FPGA of 6416SW and ATM media modules,
enter the following commands at the directory prompt:
1. SET TFTP SERVER_IP_ADDRESS (to define the server where the picocode is
stored)
2. SET TFTP FILE_NAME (to define the file on the server)
3. SET TFTP FILE_TYPE (to specify FPGA)
4. SET TFTP TARGET_MODULE (to specify the slot number of the 6416SW or ATM
media module)
5. DOWNLOAD INBAND (to load new hardware picocode)
6. SWAP FPGA_PICOCODE (to change the picocode in the module). This causes an
automatic reset of the ATM subsystem.
Uploading Dumps
To upload a dump to the host, enter the following 6416SW commands at the directory
prompt:
1. DUMP TRS (to take a dump of the topology of the network)
2. SET TFTP SERVER_IP_ADDRESS (to define the server connected to the 6416SW
module)
3. SET TFTP FILE_NAME (to define the path name of the file on the host)
4. SET TFTP FILE_TYPE (to specify a dump)
5. UPLOAD INBAND (to upload the dump).
6-7
