TELNET Sessions Via a Remote Switch
The 6416SW’s remote login feature allows you to log on to an 6416SW from a remote
configuration console or network workstation that supports the TELNET protocol.
You can remotely log on to only one 6416SW at a time.
Minimum Local Configuration
Before you can log on to the 6416SW from a remote switch, you must perform a
minimum configuration using a configuration console (in either Normal or SLIP mode).
The minimum configuration that is required depends on the type of subnetwork you will
use for the TELNET session:
Classical IP
Set the ATM address of the 6416SW
Enable the port that connects to the ARP server
Get the ATM address of the ARP server
Set the ARP server ATM address in the 6416SW
Set the IP address of the 6416SW
Enable the port that will be used for the TELNET session.
LAN Emulation
Set the ATM address of the 6416SW
Start the LEC.
These steps are described in Chapter 5, “Configuring the ATM Switch/Control Module”
on page 5-1.
4-12 ONcore ATM Switch/Control Module: Installation and User's Guide
