A SERVICE OF

logo

Installing the 6416SW Module
To install a 6416SW module in the ONcore hub, follow these steps:
1. Install the ONcore hub in its rack or on a desktop by following the instructions in the
3Com ONcore Hub Installation Guide
(17-00362).
2. Insert the 6416SW module into slots 9 and 10 (or slots 11 and 12 in A17 models) of
the hub by matching the top and bottom board guides as you slide the module
cleanly into place (by pressing evenly on the top and bottom of the faceplate). Do
not attempt to push the module all the way into the hub until you have verified that
the top and bottom module ejectors are OPEN (see Figure 2-2 on page 2-4.)
3. Make sure that the module is plugged into the connectors on the ATM backplane.
STAT
STAT
RESET
RESET
MODULE
RESET
MODULE
RESET
ACTIVITY
ACTIVITY
PO RT1
PO RT1
1
1
2
2
3
3
4
4
PO RT2
PO RT2
PO RT3
PO RT3
PO RT4
PO RT4
12
3
4
56
7
8910
1112
13
14
1516
17
Slots
RS-232
CONSOLE
RS-232
AUXILIARY
WRONG
SLOT
A-SCPSW
STBY
RUNNING
ACTIVE
MAINT
RESET
ATM
RESET
ERROR
Figure 2-1. Installing the 6416SW Module in an ONcore Hub
2-3