A SERVICE OF

logo

Open as PDF
next previous
Enabling ATM Ports and Interfaces
Before you can use the devices attached to the ATM media ports in the 6416SW, you
must enable each port and configure the type of interface used by the port to receive
and transmit ATM data. For example, to enable port 2 (‘slot’ 1) as a UNI port:
ONcoreATM> set port 1.2 enable uni [ENTER]
You can set a port to any of the ATM interfaces:
User-to-Network (UNI)
Switch-to-Switch (SSI)
Network-to-Network (NNI).
See “Network Interfaces” on page 3-6 for more information on ATM network interfaces.
Disabling an ATM Port
You could use the SET PORT command to disable an ATM port that is connected to a
failing device as follows:
ONcoreATM> set port 1.2 disable [ENTER]
5-15