REPLY_MODE ENABLE. Your NNI port is now redirecting Received Cells to
the transmit side. Now, from the ATM Analyzer, generate traffic on the VCI=5,
and compare the outgoing cells with the incoming cells. If some cells are lost or
corrupted, contact your public network provider. When you are finished, enter
the command WRAP slot.port REPLY_MODE DISABLE.
Hardware wrap test through the WAN up to the media module, install the ATM
Analyzer at one side of the WAN, and the ONcore hub/CELLplex 4000 at the
other. Enable your NNI port, and create a PVC from the VCI=x to a VCI=y on
the same port, using the command SET PVC. Check that the PVC is active
using the command SHOW PVC ALL. Now, from your ATM Analyzer, generate
traffic on the VCI=x, and compare it with the received cells on the VCI=y. If
some cells are lost or corrupted, contact your 3Com representative.
7-46 ONcore ATM Switch/Control Module: Installation and User's Guide
