A SERVICE OF

logo

ONcoreATM>set device lan_emulation_client eth ip_address 9.1 .2 .55 [ENTER]
Client starting.
ONcoreATM>
After the eth parameter, the other parameters may be entered in any order.
The first time the SET DEVICE LAN_EMULATION_CLIENT ETH is used, you must
configure all four parameters before saving the configuration settings (no default values
are provided). Once the configuration settings have been saved, it is possible to change
only one parameter at a time using the SET DEVICE LAN_EMULATION_CLIENT
command.
5-20 ONcore ATM Switch/Control Module: Installation and User's Guide