A SERVICE OF

logo

ONcore LEC Cannot PING another Client and Vice-versa
Steps to Take:
1. Check that the port of the LEC is enabled. If it is enabled, and not OKAY, then the
problem comes from the LEC or from the cable attached to it.
2. The LEC does not support the same Ethernet type as the ONcore LEC.
Check that the LEC is emulating IEEE 802.3
Ethernet frames.
3. If the ONcore LEC and the other LEC are not in the same IP subnet, there may be
a Gateway definition problem.
Check the Default Gateway addresses in both machines. In general, they
correspond to one common gateway.
7-28 ONcore ATM Switch/Control Module: Installation and User's Guide