either get a new source (re-install the source file from your installation
package), or, if it fails again, contact your 3Com Service or 3Com
representative.
8. Message: Flash memory failure/hardware-error.
Try to download several times. If it always fails, contact your 3Com
representative.
9. Message: Target Blade Mismatch.
You tried to download FPGA picocode that is incompatible with the target
module number. Check the type of module (6404M-100, 6402M etc.) and the
TFTP parameter.
ATM hub cannot restart after a download inband operation is performed and
TFTP-supported services are operational.
Steps to Take:
1. Use the DOWNLOAD OUT_OF_BAND command to load the microcode that was
previously active. Then restart the hub.
2. If the hub still does not start, replace the 6416SW module in the hub.
3. Contact your 3Com service representative.
7-38 ONcore ATM Switch/Control Module: Installation and User's Guide
