A SERVICE OF

logo

Open as PDF
next previous
ATM Reset Button
The ATM Reset button resets the 6416SW and all ATM media modules in the ONcore
hub. All data traffic and connections in the ATM subsystem are stopped.
Press this button when instructed after you correct an error condition. Before pressing
it, be sure to save any configuration settings entered in the current session with the
SAVE command. When you press the ATM Reset button, all unsaved settings will be
lost.
The button is recessed on the front panel to prevent it from being accidentally pressed.
To press it, use a pen or a small screwdriver to hold the button down.
Pressing the ATM Reset button has the same effect as entering the RESET
ATM_SUBSYSTEM FORCE command from the 6416SW console.
2-12 ONcore ATM Switch/Control Module: Installation and User's Guide