A SERVICE OF

logo

7. Configure the IP stack SLIP with the IP address of the 6416SW and verify the
6416SW-to-workstation connectivity by issuing a PING request.
C:\ping 9.1 .86.138 [ENTER]
8. Start a TELNET session to the 6416SW.
ONcoreATM> telnet 9.1 .86.139 [ENTER]
9. Logon as administrator. The Welcome screen is displayed:
Password:
Welcome to system administrator service on ONcore.
ONcoreATM>
You can now proceed to configure the 6416SW, as described in Chapter 5,
“Configuring the ATM Switch/Control Module” on page 5-1.
Returning to Normal Mode
To switch the configuration console port back to Normal mode, use the SET TERMINAL
CONSOLE_PORT_PROTOCOL command.
ONcoreATM> set terminal console_port_protocol normal [ENTER]
Note: An 6416SW RESET restores the configuration console port to NORMAL
operating mode.
4-9