SET LOGICAL_LINK command 3-8, 5-16
SET MODULE command 5-32, 5-33
SET PORT command 5-15, 5-32
SET STATIC_ROUTE command 5-16
SET TERMINAL HANGUP command 4-16
SET TERMINAL PROMPT command 5-11
SET TERMINAL TIME_OUT
command 5-12
SHOW MODULE command 5-29
SHOW PORT command 5-29
slot positions for 6416SW module 1-5
slot positions in hub 2-3
SMIT facility 7-25, 7-27, 7-28, 7-29, 7-31
SNMP
access rights 5-22
ARP server 5-21
community table 5-22
default gateway 5-21
functions supported 1-9, 6-2
IP address 5-18
managing ATM subsystem 5-17, 6-1,
7-50
subnetwork mask 5-18
traps 5-22
software upgrades 6-5
specifications
electrical A-2
environmental A-2
general A-1
mechanical A-2
SSI
See
switch-to-switch interface
Standby LED 2-10
static routes, configuring 3-11
stop bits, configuring 4-7
subnetwork mask, configuring 5-18
subnetworks 3-4, 3-6, 3-8, 5-15, 5-16
subsystem, ATM in ATM Workgroup
Switch 3-3
subsystem, ATM in ONcore hub 1-2
switch-to-switch interface 1-8, 3-6, 5-15
switched virtual connections (SVCs) 1-7,
1-9
switching
ATM cells 1-6
over ATM backplane 1-3
T
technical specifications A-1
TELNET command 4-12
TELNET protocol 6-1
timeout, configuring 4-7, 4-14, 5-12
traces
uploading to host 6-8
traffic management in ATM
subsystem 1-11
traps
error conditions 7-50
on console 7-50
troubleshooting 7-1
address registration 7-22
ATM connections 7-47, 7-48, 7-49
ATM modules 7-14
ATM ports 7-15, 7-19, 7-20
ATM services 7-34
configuration 7-10
console problems 7-11
contacting 3Com service
engineers 5-11, 7-51
from 6416SW LEDs 7-6
from ATM media LEDs 7-4
hardware 7-23
installation 7-2
Index
X-6
