Filter
Top Products
Setup Menus
RT-10
3-33
2. When the Video Adjust bar opens, press the remote control
and arrows to highlight the Video Setup option. Then, press
the remote control ENTER button to select this option.
3. When the Video Setup bar opens:
• Proceed to step 4 to configure memory banks from the
Video Setup bars shown on the previous page. The Video
Setup bars allow Video Adjust parameters to be viewed on
17 separate bars.
• Press the remote control DISPLAY button to configure
memory banks from the Video Setup screens shown above.
The Video Setup screens allow Video Adjust parameters to
be viewed on two screens.
4. When the desired Video Setup view is selected, press the
and arrows to scroll through Video Adjust parameters.
• When a Video Setup bar is open, the selected parameter
appears on the bar.
• When a Video Setup screen is open, the selected parameter
is highlighted. The cursor automatically toggles between
the two screens when the last parameter on Page 1/2 or
the first parameter on Page 2/2 is passed.
Page 1/2
Prog. Motion fast slow
PureCinema Auto1 Auto2 On Off
YNR off max
CNR off max
MNR off max
BNR off max
Sharpness High soft fine
Sharpness Mid soft fine
Memory Off 1 2 3
Auto1PureCinema
Off
Page 2/2
Detail off max
White Level min max
Black Level min max
Black Setup 0IRE 7.5IRE
Gamma + –
Hue green red
Chroma Level min max
Chroma Delay + –
Memory Off 1 2 3
Detail
Off
7.5IRE
5. When the desired parameter is selected, press the and
arrows to adjust the setting. When the desired setting is selected,
press the and arrows to continue scrolling through Video
Adjust parameters.
6. Repeat steps 4 and 5 until all desired parameter settings have
been selected.
7. When all desired parameter settings have been selected, press
the and arrows to select the Memory parameter. Then,
press the and arrows to highlight the desired memory
bank (1, 2, or 3).
8. When the desired memory bank is highlighted, press the
ENTER button to select that bank. Its settings will be applied to
pictures on the display device screen until another Video Adjust
bank is selected or factory-default settings are restored.
• When Off is selected, the selected settings are applied to
the picture on the display device screen until a Video
Adjust bank is selected, factory-default settings are
restored, or the RT-10 is powered off with the front panel
On/Off button.
. . . Video2 continues on page 3-34