Filter
Top Products
Setup Navigator
Prompt
Available Settings
Associated Setup
Menu Parameter(s)
Setup Menus
RT-10
3-3
Setup Navigator
OSD Language
TV Type
Analog Jacks
Center Speaker
• Start • Auto Start Off
• Widescreen (16:9) • Standard (4:3)
• Present `
• Not Present
• 2 Channel
• 5.1 Channel `
• Not Connected
•No
• Yes `
• Don’t Know
• Save Changes
• Delete Changes
• Start Again
• English
• français
• Deutsch
• Italiano
• Español
• Dolby Digital
• Dolby Digital/
DTS `
• Dolby Digital/
MPEG
• Dolby D/DTS/
MPEG
• PCM
• Not Connected
Setup Navigator
(General tab, 3-42)
OSD Language
(Language tab, 3-36)
TV Screen
(Video1 tab, 3-25)
Audio Out
(Audio2 tab, 3-16)
Speaker Setting
(Audio2 tab, 3-18)
Surround Speakers
• Present `
• Not Present Speaker Setting
(Audio2 tab, 3-18)
Sub-woofer
• Present `
• Not Present Speaker Setting
(Audio2 tab, 3-18)
Linear PCM Out
(Audio1 tab, 3-13)
None
Dolby Digital Out (3-12)
DTS Out (3-13)
MPEG Out (3-14)
(Audio1 tab)
Digital Jack
96kHz PCM Audio
Exit Setup Navigator
Setup Navigator Prompts
The table shown at the right lists
all Setup Navigator prompts,
along with their possible settings
and associated Setup menu
parameters.
Note:
Setup Navigator prompts should
be configured while the disc
drawer is empty.
`This setting is recommended
when the RT-10 is connected to
an MC-12 or MC-8 Digital
Controller. When no setting is
indicated, any setting can be
selected.
. . . Setup Navigator continues on page 3-4