Filter
Top Products
Setup Menus
RT-10
3-9
Exit Setup Navigator Save or Delete Changes, Start Again
Determines whether Setup Navigator prompt settings are saved,
deleted, or reentered. Select Save Changes to save prompt settings
and close the Setup Navigator. Select Delete Changes to delete
prompt settings and close the Setup Navigator. Select Start Again
to reenter prompt settings. The OSD Language prompt (3-4) will
open on the on-screen display. The Exit Setup Navigator prompt is
not associated with a Setup menu parameter.
SETUP MENU
The Setup menu can be used to configure audio, video, language,
and other general RT-10 settings. Available in expert and basic
display modes, the Setup menu can be configured for the desired
level of control. The Setup Menu Mode parameter (3-42) can be
used to select the mode in which the Setup menu is displayed.
Setup Menu Mode Expert, Basic
Determines the mode in which the Setup menu is displayed. Select
Expert to display the Setup menu in expert mode, which includes
all available parameters. The Setup menu is shown in expert mode
at the top of the next page. Select Basic to display the Setup menu
in basic mode, which only includes parameters that are required to
configure the most common RT-10 settings. When displayed in
basic mode, the Setup menu also includes a tutorial to describe the
highlighted menu item. The Setup menu is shown in basic mode
at the bottom of the next page.
To navigate the Setup menu:
Button Command
ENTER Selects the highlighted parameter or setting.
and Scroll left and right through Setup menu tabs.
When a parameter is highlighted, pressing the
arrow selects that parameter.
and Scroll upward and downward through Setup
menu tabs, parameters, and settings.
RETURN When a Setup menu tab is highlighted,
pressing the RETURN button closes the Setup
menu without saving parameter settings that
have been selected since the Setup menu was
opened. When a parameter or setting is
selected, pressing the RETURN button closes
the selected parameter without saving
changes. When this occurs, the cursor moves
to the selected Setup menu tab.
SETUP Closes the Setup menu. (The Setup menu
automatically closes a few seconds after the
last command is received.)
To open the Setup Menu:
Press the remote control SETUP button.