Lexicon RT-10 CD Player User Manual


 
Setup Menus
RT-10
3-19
Setting Speaker Sizes
The Speaker Size screen shown above can be used to set speaker
sizes and crossover points for the front, center, surround, and
subwoofer speakers. Refer to the manufacturer documentation to
determine the low-frequency response of each speaker.
Note:
Speaker size settings have no effect when:
A DVD-A is loaded.
The RT-10 is using the 2-channel analog audio
output connectors.
The RT-10 is using the digital audio output
connector.
To set speaker sizes and crossover points:
1. When the Speaker Size screen opens, press the remote control
and arrows to highlight the desired parameter.
2. When the desired parameter is highlighted, press the and
arrows to cycle through available settings.
3. When the desired setting is selected, press the arrow to
highlight the Size option at the top of the on-screen display.
Then, pressing the arrow to open the Speaker Distance
screen or the remote control ENTER button to return to the
Setup menu.
Note the following:
When setting the C, LS, and RS parameters, select Small to
apply a 100Hz crossover point through the associated
channel(s). Select Large to provide full-range audio output
through the associated channel(s). Select Off if the associated
speaker is not present.
If the low-frequency response of the associated speaker cannot
be determined, select Small if the main cone of the associated
speaker is less than 6 inches (12cm). Select Large if the main
cone of the associated speaker is greater than 6 inches (12cm).
. . . Audio2 continues on page 3-20
Audio Out --- 2 Channel
Speaker Setting
Gain Setting --- Fix
CD Digital Direct --- Off
A1 Language GeneralVideo1Audio2 V2
Move Select Exit
SETUP
StartSpeaker Setting
ENTER
L/R --- Large
C --- Large
LS --- Large
RS --- Large
SW --- On
Speaker Setting
A1 Language GeneralVideo1Audio2 V2
Distance Select Exit
Return
Size
ENTER SETUP
LCR
LS RS
SW
L/R --- 10.0ft
C --- 10.0ft
LS --- 10.0ft
RS --- 10.0ft
SW --- 10.0ft
Speaker Setting
A1 Language GeneralVideo1Audio2 V2
Size Select Exit
Return
Distance
ENTER SETUP
LCR
LS RS
SW
ENTER