Filter
Top Products
Troubleshooting & Maintenance
Lexicon
5-14
Program playback is in progress, and playback of a
non-programmed chapter or track begins.
1. When playback of a program chapter or program track list is
activated, playback of a non-programmed chapter or track
might activate while the RT-10 searches for the next
programmed chapter or track.
Search mode will not activate.
1. Make sure the search mode is compatible with the loaded disc.
The table on page 4-12 indicates the search modes that are
available for each disc format.
2. Close the disc menu. Some search modes might not activate
when the disc menu is open on the on-screen display.
3. If frame + time search mode is selected:
• Activate playback or pause mode. Frame + time search
mode is not available when stop or resume mode is
activated.
• Make sure the Frame Search parameter (3-28) is set to On.
frame + time search mode is not available when the Frame
Search parameter is set to Off.
• Some discs do not allow frame + time searches.
Some frames are skipped during frame-by-frame
playback, or frame + time search mode does not find the
selected frame number.
1. Make sure frame-by-frame playback or frame + time search
mode is available for the loaded disc. The table on page 4-12
indicates the playback modes available for each disc format.
Playback Control Issues (continued from page 5-13)
A certain value cannot be added to a program list (4-22).
1. Program lists cannot contain values 100 and above or values
that are not included on the loaded disc. For instance, a
program title list cannot include a value of 5 if the loaded disc
does not include title 5.
2. The program list must include at least one blank field before a
new value can be inserted.
A program list is not stored.
1. Make sure a DVD-V or DVD-RW/R is loaded. Program lists
cannot be stored for other disc formats.
2. Make sure the Program Memory parameter is set to On. When
this parameter is set to On, program lists for the loaded disc are
stored until factory-default settings are restored. When set to
Off, program lists for the loaded disc are automatically deleted
when the disc drawer is opened, standby mode is activated,
the RT-10 is powered off, or factory-default settings are
restored.
Program list modifications are not saved.
1. Program tabs automatically close a few seconds after the last
command is received. When this occurs, all program list
modifications that have not been previously stored will be
deleted.