Filter
Top Products
Possible
Distance Settings
Default
Distance Setting
Possible
Size Settings
Default
Size Setting
Parameter
Setup Menus
Lexicon
3-18
Audio2 (continued from page 3-17)
Speaker Setting Start
Opens the Speaker Setting screens, which can be used to set
speaker sizes and distances when the RT-10 is using the 5.1-channel
analog audio output connectors. Speaker size and distance settings
have no effect when the RT-10 is using the 2-channel analog audio
output connectors or digital audio output connector.
• Large†
• Small `
• Large `
•Off
• Small `
• Large `
•Off
L/R
C*
LS*
RS*
Large†
Large
Large
` These settings are recommended when the RT-10 is connected to an MC-12 or MC-8 Digital Controller. When no setting is indicated, any setting
can be selected.
* These Speaker Setting parameters are associated with the Setup Navigator Center Speaker (3-6), Surround Speakers (3-6), and Sub-woofer (3-7)
prompts.
† The L/R size parameter setting cannot be adjusted. This parameter has a fixed Large setting to provide full-range audio output through the front
left and right channels.
• 1.0 to 30.0ft
• 1.0 to 36.5ft
• 1.0 to 36.5ft
10.0ft `
10.0ft `
10.0ft `
• Small `
• Large `
•Off
Large • 1.0 to 36.5ft
10.0ft `
SW*
• On `
•Off
On • 1.0 to 36.5ft
10.0ft `
Note:
RT-10 speaker settings do not need to be configured
when the RT-10 is connected to an associated
component such as the MC-12 Digital Controller,
which allows speaker settings to be configured for
analog audio sources. The associated component must
not be using analog audio connections in bypass.