Filter
Top Products
Troubleshooting & Maintenance
RT-10
5-7
RF interference is present in the audio output.
1. Make sure the RT-10 is not positioned near unshielded TV or
FM antennas, cable TV decoders, and other RF emitting devices
that might cause interference. Replace unshielded cables with
shielded cables whenever possible.
Volume level seems to differ between DVDs and CDs.
1. DVDs and CDs are recorded with different processes, which
might cause them to output audio at different volume levels.
The RT-10 will not pass Dolby Digital, DTS, or MPEG
signals to the associated component.
1. Make sure the Dolby Digital, DTS, and MPEG parameter (3-12
to 3-14) settings are compatible with the associated
component. For instance, the Dolby Digital parameter should
be set to Dolby Digital if the associated component is
compatible with Dolby Digital sources and to Dolby
DigitalPCM if the associated component is not compatible
with Dolby Digital sources.
2. Make sure all associated components are configured with the
correct settings.
PLAYBACK ISSUES
The disc drawer automatically opens when a disc is
loaded.
1. Make sure a compatible disc is loaded. The RT-10 is compatible
with 5-inch (12cm) and 3-inch (8cm) conventional, round
discs. Do not attempt to load discs with other size and shape
characteristics, such as those shown below. All discs must align
with the circular guide inside the disc drawer.
2. Make sure a compatible disc format is loaded (1-5).
3. If a DVD-V is loaded, make sure the RT-10 region code is
compatible with the DVD-V region code. The map shown on
page 1-4 indicates DVD-V region codes for all areas of the
world. All DVD-Vs are marked with a region code, which is
often located on the disc packaging. The RT-10 rear panel is
also marked with a region code (2-8). The RT-10 is compatible
with discs marked with this same region code or with the ALL
region code. The RT-10 is not compatible with discs marked
with other region codes.
4. Clean the loaded disc (5-16).
5. Condensation might have formed on the RT-10 lens (1-4). If
this occurs, allow at least 1 hour for condensation to evaporate
before attempting to load a disc.
. . . Playback Issues continues on page 5-8