Filter
Top Products
Troubleshooting & Maintenance
Lexicon
5-4
An icon appears on the on-screen display.
1. The icon shown at the right appears on the on-screen
display when the RT-10 does not allow the selected
command.
2. The icon shown at the right appears on the on-screen
display when the loaded disc does not allow the
selected command.
3. The icon shown at the right appears on the on-screen
display when a Setup menu parameter that is
exclusive to DVD formats is adjusted while another
disc format is loaded. These adjustments will take
effect the next time a DVD is loaded.
4. When the Setup menu is open, the icon shown at the
right appears next to parameters for which Setup
menu shortcuts (3-50) have been created.
5. When the MP3 Navigator (4-4 and 4-27) is open, the
icon shown at the right appears next to MP3 tracks
that have been added to the MP3 program list.
AUDIO OUTPUT ISSUES
The RT-10 is powered on, but there is no audio.
1. Deactivate the following playback modes (if applicable): stop
mode, resume mode, pause mode, still frame playback, frame-
by-frame playback, and slow playback. Audio automatically
mutes when these playback modes are activated.
2. Examine the rear panel to ensure that the required audio
output connection (2-12) has been made and that audio
cables have been fully inserted.
Video Output Issues (continued from page 5-3)
The picture on the associated display device screen
includes video artifacts. (continued)
4. The RT-10 is not compatible with all high-definition display
devices. In some cases, this connection might produce video
artifacts in the picture.
5. The RT-10 includes copy-protection circuits that might prevent
recording or produce video artifacts in the picture when the
RT-10 is connected to a VCR or A/V selector.
RF interference is present in the video output.
1. Make sure the RT-10 is not positioned near unshielded TV or
FM antennas, cable TV decoders, and other RF emitting devices
that might cause interference. Replace unshielded cables with
shielded cables whenever possible.
Still frame images shake.
1. Set the Still Picture parameter (3-35) to Field. When this
parameter is set to Field, the RT-10 produces tight, stable, and
generally shake-free still frame images.
FM