Filter
Top Products
Auto-Image
Select the Auto-Image check box for input 1 to enable an automatic Auto-Image to an
input. When enabled, Auto-Image is applied whenever there is a change in the input sync.
Auto-Image attempts to size and center the input signal based on the aspect ratio setting.
By default, the Auto-Image threshold is 25% brightness. Analog video signals greater
than the threshold are considered active video. To change the threshold value, use SIS
commands.
Auto Memory
Select the Auto Memory check box of the desired input to enable the Auto Memory. Auto
Memory recalls input and image settings for signals that have previously been applied.
When Auto Memory is disabled, the scaler treats every newly applied input as a new
source.
HDCP Authorized
Select the HDCP Authorized check box to enable or disable the HDCP Authorized
feature for inputs 2 and 3. This feature determines if a digital input will report as an HDCP
authorized sink to a source.
NOTE: This option is not available for analog inputs 1.
For source devices that require encryption, enable HDCP Authorized. If HDCP Authorized
is disabled for sources that require encryption (for example, a Blu-ray player), the output is
muted or a warning message is displayed.
Some source devices may encrypt their output even if the source material does not
require HDCP encryption, preventing content from being displayed on a non-HDCP
compliant display. Disable HDCP Authorized to allow the output of the scaler to remain
unencrypted.
Film Detect
Select the Film Detect check box of the desired input to enable automatic 3:2, 2:2, and
24:1 film pulldown detection for NTSC, PAL, SECAM, and 1080i input signals.
Annotator 300 • Product Configuration Software 77