Filter
Top Products
X5( = All ports (0), USB device (1-64)
X6! = Video Signal Status
0 = Video / TMDS signal not detected
1 = Video / TMDS signal detected
X6@ = Power Save modes
0 = Full Power mode (Default)
1 = Low Power state
X6# = Screen Saver Status
0 = Active Input; timer not running
1 = No active input; timer is running; output sync still active
2 = No active input; timer has expired; output sync disabled
X6$ = File location
0 = Internal Flash
1 = Image Quick Capture PC (requires Image Quick Capture software)
2 = Attached USB drive (Only ONE USB drive can be connected)
3 = Network location (location must be configured or E25 will be issued)
X6% = Image Capture File Format
1 = JPG
2 = BMP (default)
X6& = Network folder path (spaces not allowed)
Example: 10.13.198.131/AnaheimCourt/Room20
X6* = Printer URI address
Example: lpd://197.168.254.201
NOTES:
• “lpd” must be lower case
• Contact your IT department to determine if your printer supports postscript
printing via LPD.
X6( = Auto Annotation Clear
0 = Disabled (default)
1 = Clear after an input switch
2 = Clear after an input switch or when a new input frequency is detected
X7! = Output Group Selection
0 = All outputs (Default)
1 = Output 1 Only (HDMI)
2 = Output 2A and 2B Only (HDMI & DTP)
3 = None
X7@ = White/Blackboard status
0 = Disabled (Default)
1 = Whiteboard is enabled
2 = Blackboard is enabled
X7# = Auto Switch Mode
0 = Disable (Default)
1 = Gives priority to the highest numbered active input
2 = Gives priority to the lowest numbered active input
X7$ = DTP Output Format
0 = DTP format (Default)
1 = HDBaseT Format
Annotator 300 • SIS Communication and Control 39