Filter
Top Products
Command ASCII command
(host to processor)
Response
(processor to host)
Additional description
Auto Memories
Enable
EX!*1AMEM} AmemX!*1
]
Set auto memory on. Previous settings
for incoming signal are auto recalled.
Disable
EX!*0AMEM} AmemX!*0]
Set auto memory off. Default settings
are always used unless input preset is
recalled manually.
View setting
EX!AMEM} X1)] View auto memory status for X!.
Advanced Configurations
Test pattern
Set test pattern
EX2)TEST} TestX2)]
Select test pattern
X2)
.
View test pattern
ETEST} X2)]
View which test pattern is used.
Freeze
Enable
1F
Frz1]
Freeze selected input.
Disable
0F
Frz0]
Unfreeze selected input.
View setting
F
X1)]
View freeze setting.
Auto Switch mode
Disable
E0AUSW
}
Ausw0]
Manual input switching only.
High to Low (3 to 1)
E1AUSW} Ausw1]
Gives priority to the highest active
input.
Low to High (1 to 3)
E2AUSW} Ausw2]
Gives priority to the lowest active
input.
View setting
EAUSW} X7#]
View current setting.
Switch effect
Cut
E0SWEF
}
Swef0]
Sets the switch effect to cut.
Fade
E1SWEF} Swef1]
Sets the switch effect to fade through
to black.
View setting
ESWEF} X4%]
View effect setting.
Front panel lockout (executive mode)
Enable Mode 1
1X
Exe1]
Lock out entire front panel.
Enable Mode 2
2X
Exe2]
Limited front panel adjustments.
Disable
0X
Exe0]
Adjustments and selections can be
made from front panel.
View front panel lock
status
X
X2(]
Show executive mode status.
NOTE: For full lock mode details see the “Setting the Front Panel Locks (Executive Modes)” section.
NOTE: X! = Input selection; 1 – 3
X1)
= off/disable (0), on/enable (1)
X2) = Test patterns: 0 = off (default), 1 = Crop, 2 = alternating lines, 3 = alternating pixels, 4 = crosshatch,
5 = 4x4 crosshatch, 6 = color bars, 7 = grayscale, 8 = ramp, 9 = white field, 10 = 1.33 aspect ratio,
11 = 1.78 aspect ratio, 12 = 1.85 aspect ratio, 13 = 2.35 aspect ratio, 14 = blue mode
X2( = Executive mode status: 0 = Off / disabled (default), 1 = Exe Mode 1 - Complete front panel lockout,
2 = Exe Mode 2 - Partial front panel lockout (only input selection and Auto-Image are still available)
X4% = Video Switching Effect; 0 = Cut, 1 = Fade through Black (default)
X7# = Auto Switch Mode; 0 = Disable (Default), 1 = Gives priority to the highest numbered active input,
2 = Gives priority to the lowest numbered active input
Annotator 300 • SIS Communication and Control 47